Installation Instructions - Built In - Danby Products Silhouette Select DOAR154SSST Guide D'utilisation Et Soins De Propriètaire

INSTALLATION INSTRUCTIONS - BUILT IN

*NOTE: Your outdoor all refrigerator can be built in. The unit may not be energy star compliant once built in.
TOOLS YOU WILL NEED
While performing installations described in
this section gloves and safety glasses or
goggles should be worn.
PREPARING THE ENCLOSURE
ELECTRICAL REQUIREMENTS
The appliance must be connected to an
individual, properly grounded electrical
outlet protected by a 15 or 20 ampere circuit
breaker or time delay fuse.
• Remove the screws (see Fig.1. number (2) 4
screws total) from the compressor back cover and
take out the compressor cover (see Fig.1. number 1)
before installing the unit. Please keep all components
that you take out from the back of the unit. (Fig.1)
• Keep the spare caster
• It is recommended that you do not install the outdoor
all refrigerator into a corner (i.e. directly beside a
wall). This is to allow the door(s) to have a greater
then 90° opening swing. A limited door swing will
prevent the shelves from sliding out as intended, and
may lead to damaging the door gasket(s).
• The rough cabinet opening must be on a level floor
area and at least 26" deep by 24" wide. The
opening should also have a height of at least
34 2/4".
• The electrical outlet may be positioned from within
either side of the adjacent cabinetry, or the rear of
the shaded area (as shown in Fig 2.).
• If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2" diameter hole to admit
the power cord. If the cabinet wall is metal, the hole
edge must be covered with a bushing or grommet.
Fig.1
1
2
Fig.2
Fig A
3
34 2/4" from
34 /4 " from
underside of
underside
countertop to
of
floor.
countertop
to floor
3
BACK
BACK
1
1 1/2" diam. hole
1 /2 "d iam. hol e
* If electrical outlet
* I f electrical out -
is in adjacent
let is in adjacent
cabinetry.
cabinetry .
26"
Electrical Access
24"
Cabinets
Cabinet s
square
square
and plumb
and
plumb