Air Circulation; Water Drainage; Timer Setting - ZIBRO CLIMA P7000 Manuel D'utilisation

3 .
C
A A
C C
D
4
30
2001 P7000 / P9000

AIR CIRCULATION

Press the 'MODE' button ¹ to select the circulation function.
1
on the display.
Select the desired ventilator speed with the 'FAN SPEED' button ¸: high,
2
medium or low
'LOUVER' BUTTON
Pressing the 'LOUVER' button
'turn' from left to right and back again to distribute the air over a larger area.
Pressing the 'LOUVER' button again de-activates this function.

WATER DRAINAGE

The red warning light ¾ will flicker and the machine will emit a sequence of 8
audible signals when the water reservoir is full. A safety system ensures that the
compressor is switched off after 3 minutes. However, the ventilator will continue
to circulate air. Switch the machine off before removing and emptying the water
reservoir (fig. A).
EXTERNAL DRAINAGE DUCT
If required, it is possible to connect a drainage hose to the machine.
To do this, follow the directions below:
Pull the drainage spout º out of the machine.
1
2 Connect the small hose to the drainage spout (fig. C).
3 Drain the water through the hose to a water storage container.
4 Remove the hose after use. Perform these operations carefully to ensure that
the drainage duct remains intact.
'TIMER' SETTING
Using the Timer setting, the airconditioner will turn on or off automatically. To do
this, follow the directions below:
1 Press the 'TIME SET' button
OFF will appear on the display.
Select with the 'TIME SET' button after how many hours you want the
airconditioner to de-activate.
2 Press the 'TIME SET' button
and ON will appear on the display.
Select with the 'TIME SET' button after how many hours you want the
airconditioner to activate.
.
activates an extra option. The vertical blinds
while the airconditioner is activated. 24 Hr and
while the airconditioner is de-activated. 24 Hr
will appear