König KN-BM60 Mode D'emploi page 3

After the software installation is complete,
2
click the icon
Default "uCare Cam" password: 0000
Manager's Name: admin
Manager's Password: 0000
There are two options to continue the easy set-up of your IP baby and child monitor.
Install your IP baby and child monitor by ROUTER MODE
Power On
1
Plug the power adapter DC connector into the DC input port of the IP baby and child
monitor and then plug the power adapter into a wall outlet. The status LED on the IP
baby and child monitor will turn green for about 15 seconds.
Programme Loading
2
The status LED will flash red for about 15 seconds.
Router Link Mode
3
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset button for more
than 10 seconds to restart the IP baby and child monitor.
When the green status LED lights up and holds, and then the red status LED flashes
twice, after which it changes into green, the IP baby and child monitor has entered
the RESET state. At this moment you can release the button and then wait until the
status LED alternates between red and green.
ANDROID (for Apple go to: Step 8)
Set the IP baby and child monitor to connect to the Wi-Fi Router
4
Open the "uCare Cam" App
Window (see Figure 1).
5
In the following screen select the tab:
to run the app.
and select:
3
ENGLISH
Figure 1
"Camera List Window"
in the screen of the Camera List