Prior To Initial Operation; Switching On - Switching Off; Selecting The Operation Mode - Redstone RS 1400-60 CE Notice Originale

This power tool is equipped with a
mechanism for reducing vibrations, decreasing
them by more than 50%.

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
Application
Render / Light construction
materials
Chiselling tiles
Bricks
Drilling in concrete
Chiselling concrete
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.

SWITCHING ON - SWITCHING OFF

▪ Switching on: Push and hold down switch 7.
▪ Switching off: Release switch 7.
At low temperatures, demolishing with the pow-
er tool must begin only after it was operated for
about 3 minutes at no-load mode.
18
EN
chine with 30% the red light-emitting diode 10
will glow. The machine must not be operated
conti nuously in this mode.
SELECTING THE SPEED, FREqUENCY
AND IMPACT ENERGY
Rotate the regulator 8 to choose a position
appropriate for the processed material. The
constant electronics maintain the speed, the
frequency and the impact energy constant, in-
dependently of the load, thus ensuring steady
operation mode. It is recommended to use the
operation modes listed in the table.
Regulator Rotation
position speed
A-C 120-145 min
C 175 min
D 200 min
E-F 225-250 min
G
Rotate the regulator 8 from position A to position
F to increase the speed, the frequency and the
impact energy. The indicator 9 shall blink with
green light.
To choose High Power mode, rotate the regula-
tor 8 to position G. This mode is specified by in-
creased impact energy up to 12 J. The indicator
9 shall glow with constant green light.
mode is recommen ded only when chiselling
(hammer mode), and for brief operation in
impact drilling mode. Continuous operation in
impact drilling mode shall result in operator's
quick fatigue and increased wear-out of the
machine.

SELECTING THE OPERATION MODE

The switching of operation modes can be per-
formed when the machine is not operating.
Rotate the operation mode switch 6 in the direc-
tion marked on the switch to the desired position
to choose.
WARNING: Upon overloading the ma-
Impact rate
1150-1450 min
-1 -1
1700 min
-1 -1
1950 min
-1 -1
-1
2800 min
-1
WARNING: Using HIGH POWER
RS 1400-60 CE
Single impact
energy
1.5-2.5 J
7 J
8 J
9-10 J
12 J