Operation; Cleaning - Proficook PC-SMS 1220 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
1. Press both buttons (5) simulta-
neously.
2. Place the motor housing (4) on the
mixing rod (6) or on the pre-as-
sembled egg whisk (8) and snap it
into place. The arrow on the motor
housing and the symbol on the
accessory must be positioned one
above the other. Pay attention to
the recesses on the accessory.
3. Release the buttons. The motor
housing and the accessory are
firmly connected.
• To disassemble, pull the accessory off the motor housing
while you hold the two buttons down.
Electrical Connection
1. Ensure that your mains power corresponds with the
specifications of the appliance. The specifications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.
WARNING:
• Always remove the plug before cleaning.
• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an
electric shock or fire.
• The blade of the hand blender is very sharp! Please be very
careful.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not immerse the gear unit for the egg whisk (9) in
water! Wipe it using only a damp cloth.
NOTE:
For preliminary cleaning, place the accessory in a vessel
containing hot water and run the egg whisk and / or the
mixing rod as described under "Operation".
• Wipe the casing with a damp cloth.
• For thorough cleaning, separate the assembled
accessory from the motor housing as described under
"Assembly / Disassembly".
34
PC-SMS1220_IM
WARNING:
When using the appliance in hot foods, there is a risk of
burning due to hot splashing.
1. Submerge the entire blender head in foodstuff or bever-
age. Keep the appliance upright. In this way you avoid
spatters.
2. Hold the handle with one hand in such a way that you
can press the push button (3). Use the other hand to
adjust the speed with the control knob (2).
3. Activate pulse operation by pressing and releasing the
push button alternately.
4. The appliance turns off when releasing the push button.
WARNING: Risk of injury!
The motor overtravels. Wait for the assembled acces-
sory to stop running.
5. Pull out the plug from the socket after use.

Cleaning

Cleaning In Sudsy Water
You can rinse off the mixing rod (6) and the egg whisk (8)
in warm dishwater with a little dishwashing detergent. After-
wards, dry the accessory thoroughly.
Cleaning In the Dishwasher
The mixing rod (6) and the egg whisk (8) can be washed in
a dishwasher. Ensure not to overdose the cleaning agents
(detergent, salt and rinse aid).

Operation

26.05.21

Publicité

Table des Matières
loading

Table des Matières