ALPHA-TOOLS FSM 180 Mode D'emploi page 6

Anleitung FSM 180 AlphaTools
GB
1. Technical data
Motor rating: 500 W S3 40%
Motor speed:
AC motor: 230 V ~ 50 Hz
Insulation class:
Protection type:
Cutting height:
Cutting table:
- Dimensions 395 x 385 mm
Diamond cutting wheel ø 178 x 25.4 x 2.2
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; 11/95, DIN EN ISO 11201: 1996-07 ISO
7960 Annex A; 2/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the user's hearing
(wear ear muffs!).
Working mode
Sound pressure level LPA 79 dB(A)
Sound power level LWA 93 dB(A)
2. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
Important!
For safety reasons it is prohibited for children, young
people under the age of 16 years and all persons
who have not read and understood the operating
instructions to use the tile cutting machine.
3. Description of the machine
Portable tile cutting machine for small and
medium tiles.
Cutting performed by a diamond cutting wheel.
6
06.02.2004 10:06 Uhr
Jolly cuts with tilting work top up to 45 degrees.
Cutting wheel cooled with water.
Straight fence and mitre fence.
Removable trough as cooling water container.
(To remove: Pull out the trough as far as the stop
2800 rpm
and then lift slightly to remove completely.)
Class B
4. Intended use
IP 44
35 mm
The tile cutting machine is designed to perform
cutting jobs on small and medium tiles (floor and wall
tiles made of ceramic and similar material) which suit
the machine's size. It is intended in particular for use
by DIY enthusiasts and craftsmen. The cutting of
wood and metal is prohibited. The machine is to be
used solely for its intended purpose. Any use
other than its intended use is a case of mis-use. The
user/operator and not the manufacturer shall be
liable for any damage or injury resulting from cases
of mis-use. Only those cutting wheels suitable for the
machine are to be used. The use of saw blades is
prohibited. For the machine to be used as intended it
is also imperative to observe the safety instructions,
the assembly instructions and the operating
instructions set out in this manual. All persons
entrusted with operating and servicing the machine
must be acquainted with the manual and must be
informed about the machine's potential hazards. It is
also imperative to pay exact attention to the accident
prevention regulations in force in your country and to
Idle
observe the general rules of occupational medicine
and safety. The manufacturer can accept no liability
58 dB(A)
whatsoever for damages resulting from any
72 dB(A)
modifications to the machine. Even when the
machine is used as intended, certain residual risk
factors cannot be ruled out completely. The following
hazards may arise in connection with the machine's
design and construction:
Touching of the diamond cutting wheel in the
uncovered zone.
Reaching into the area of the diamond cutting
wheel when it is running.
Catapulting of a faulty diamond tip off the cutting
wheel.
Kicking of workpieces and workpiece parts
during incorrect operation.
Damage to hearing if ear muffs are not worn.
5. Safety instructions
Set up the machine on level, non-slip ground.
The machine should not wobble.
Make sure that the voltage on the rating plate is
Seite 6