Ninja 566.500.001 Notice D'utilisation page 39

VII. ASSEMBLING THE UNIT (suction of the product)
Depending on the size of the to be treated area, you can choose from
the following options:
a. Small surfaces
Fill a plastic bottle with the product you want to use (you can use one of
our bottles of 600 ml or 1000 ml, or any available bottle with a matching
thread), put the brass filter into the bottle and tighten it. The bottle
connection piece has a ball joint which adapts to the different
positions of the device during the treatment.
b. Large surfaces
In order to siphon the product from a reservoir, (bucket,
barrel,...) , have the brass filter connected and then insert
to the the extension tube of PVC of 9 m. The other end must
with the brass plunger must be put in the storage vessel.
Now the device is ready for use.
At the start-up put the flow controller to position 1 (wheel with size designation)
and increase it gradually.
Never submerge your 'Ninja' sprayer in a liquid.
VIII. INSTRUCTIONS FOR USE AND GENERAL INFORMATION
LITHIUM-ION BATTERY
The battery is fully charged when it has a voltage of 16.70 Volt. Make sure that the
voltage is not below 11 Volt, because will result in an irreversible damage to the
battery. A row of 3 (orange LED) lights provides information on the charging status:
3 LEDs lit
voltage > 15.5 volts
(charge status > 66 %)
2 LEDs lit
voltage between 14.5 and 15.5 volts
(charging status between 33 and 66 %)
1 LED lit
voltage between 14 and 14.5 volts
(charging status between 11 and 33 %)
CAUTION 1 blinking LED light: voltage < 14 volts (charge status < 11 %)
| 39
NINJA