General Safety - KRAFTWERK 31042 Mode D'emploi

GENERAL SAFETY

• Please read this instruction manual carefully to guarantee a correct handling of the air hose reel. Keep this
instruction manual in a safe place for future use.
• Check the device before operation for completeness, functionality and for leaks!
• Always work with caution and the necessary care!
• Make sure that no children and unauthorised persons are within in the working area.
• The hose reel consists for the most part of plastic. Do not stand on the housing of the reel. Risk of breakage!!!
• Do not use any harmful or aggressive cleaners to clean the hose.
• When retracting the hose please hold the end of the hose with both hands.
• Please note the maximum operating pressure of the device. This device should only be used within the specified
parameter. Improper use may result in personal injuries or damage to the device.
• Do not roll up the end of the hose very quickly! There is risk of injury when rolling up the hose and can lead to
material damage. Keep control while retracting the hose.
• Ensure previously that the air blast is turned off before rolling up.
• When the device is not in use please roll up the hose completely.
INSTALLATION
1. Assemble the hose reel ideally located close to the air compressor.
2. Select a stable and a supporting wall for vertical mounting.
3. During assembly please ensure that the hose reel has a sufficient swivelling range and not be exposed to very
strong solar radiation. The rewind mechanism and the plastic reel can get damaged.
4. Hold the mounting bracket on the wall and transfer the hole pattern on the wall.
5. Drill the holes for the mounting in the wall and attach the mounting bracket with the provided screws.
6. Attach the hose reel with axis on the mounting bracket.
Inlet
Outlet
6
EN