Replacement Parts And Accessories - Dennerle Trocal LED Control Mode D'emploi

4.2 PIN
A personal identification number (PIN) is provided to protected the device
against changes to settings by unauthorised persons. The factory PIN is set to
0000. When the PIN is set to 0000, all changes can be made without entering
a PIN. Once the PIN differs from 0000, the PIN needs to be entered before each
setting. This also applies for changing the PIN.
If you have Switch off the device (remove plug from power supply) and switch
forgotten on again (re-insert the plug into the power supply). Immediately
the PIN afterwards, while the status and greeting display is visible, press
 and  simultaneously. You will then be asked Delete PIN?
After confirming with yes the PIN will return to the factory setting
(0000 – deactivated).
Troubleshooting
Errors
Lights always have 100% brightness
and won't dim .
LED control is working but the
second light is not lighting up .
Lights or individual channels do
not have the level of brightness
programmed into the illumination
programme .

Replacement parts and accessories

See: www . d ennerle . c om
Possible causes/remedy
Inputs and outputs switched/Pay
attention to the assignment of
power supplies and lights and where
necessary correct.
Only one power supply is connected/
Connect the second light's power
supply.
Checking whether moon-phase
simulation is active or whether
start and end times are correctly
programmed . See point 2 . 4
15