Technical Specification - Velleman MONCOLHA3 Notice D'emploi

8. Battery
• The battery holder of the remote control is located at the back of the
remote, on the bottom. To replace the battery, pull the battery holder
away from the remote control.
• Replace the old battery with a new lithium battery type CR2025. Make
sure to use the correct polarity.
• Push the battery holder back in the remote control until it snaps into
place.
• Remove the battery when the device is not in use.
• Do not recharge batteries and do not throw in fire as they may explode.
WARNING: handle Lithium batteries with care, observe
warnings on battery casing. Dispose of batteries in
accordance with local regulations.
Keep the battery away from children.
9.

Technical Specification

display mode
screen size
resolution
number of pixels
video input signal
power supply
monitor
remote control
operating temperature 5°C ~ 40°C
storage temperature
dimensions
weight
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulted from
(incorrect) use of this device.
For more info concerning this product, please visit our website
www.velleman.eu.
The information in this manual is subject to change without prior
notice.
00 (07/11/2008)
MONCOLHA3
TFT Active Matrix (4:3)
3.5"
320 x R.G.B x 240
230400
1.0Vpp / 75 ohms (composite video signal)
DC 12V ± 10%
1 x 3V CR2025 battery (incl.)
-20°C ~ 60°C
108 x 78 x 24mm
137g
6
®
Velleman