Safety Regulations; Layout And Items Supplied - Bavaria BAC 380/50 V Mode D'emploi D'origine

Masquer les pouces Voir aussi pour BAC 380/50 V:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.

2. Layout and items supplied

2.1 Layout (Fig. 1-4)
1. Intake air fi lter
2. Pressure tank
3. Wheel (axle mounted)
4. Foot
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the set pressure)
7. Pressure regulator
8. On/Off switch
9. Transport handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the vessel pres-
sure)
13. Quick-lock coupling (unregulated com-
Anl_BAC_380_50_SPK1.indb 16
Anl_BAC_380_50_SPK1.indb 16
GB
pressed air)
14. Oil sealing plug
15. Oil drainage screw
16. Overload switch
17. Oil fi ller opening
18. Screw
19. Washer (small)
20. Nut for fi tting the foot
21. Axle screw
22. Spring washer
23. Nut for fi tting the axle
24. Washer
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
Open the packaging and take out the equip-
ment with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
Intake air filter (2x)
Wheel (axle pre-mounted) (2x)
Foot
Oil sealing plug
Screw
Washer, large
Washer, small (3x)
Nut for fitting the foot
Spring washer (3x)
Nut for fitting the axle (2x)
Original operating instructions
Safety information
- 16 -
22.07.14 09:47
22.07.14 09:47

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

40.073.55

Table des Matières