HQ Power HQSA1024 Mode D'emploi page 6

Remote Control
WARNING – Do not puncture batteries or throw them in fire as they may explode. Do
not attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in
accordance with local regulations. Keep batteries away from children.
1. Open the battery compartment and insert the batteries according to the correct
polarity. Close the battery compartment.
2. Remove the batteries if the remote control is not being used for a long time.
Replace the batteries with fresh ones as soon as you notice response is getting
weaker.
3. Aim the remote control at the front of the speaker and keep it within a range of
5 metres.
6. Operation
General Operation
1. Power on-off
Press the on-off button on the speaker or remote control to switch on the speaker.
2. Source selecting
Press the mode button to select the source between FM  Wireless  Line In 
USB  SD  FM...
3. Volume adjustment
Turn the main volume knob or press the volume buttons on the remote control to
control the volume level.
4. Treble and bass adjustment
Turn the treble and bass knobs to adjust the treble and bass tones.
5. Sound silencing
Press the mute button to mute the sound. Press again to unmute.
6. Preset EQ
Press the EQ button to select a preset EQ mode between Normal  Rock  Pop 
Classic  Jazz  News  Normal...
7. Play/pause
Press the play/pause button to play or pause the music.
8. Repeat
Press the repeat button to switch the music playback to repeat once  random 
repeat all.
9. Power and overload LEDs
The green power LED will light when the speaker is powered.
The red clip LED will light in case an overload is detected. To protect the speaker,
reduce the volume level as soon as the clip LED flashes.
V. 02 – 03/01/2019
HQSA1024/HQSA1025/HQSA1026
6 ©Velleman nv