Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank and use the pin
for positioning. Tighten the 4 screws
of fixations (Important, make sure
that the screws have the same
strength of tightening).
2. Adjust the offset of the position.
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose, using
the adapted spanners.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
S20-GSP-613
MARK :
empty positions.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation :28.08.17
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
S20-GSP-613
Mode d'emploi 1-
Page : 2 de 4
Publicité
