Karaoke Function; Led Light Circle; Cleaning And Maintenance - X4-TECH Bobby Joey Jam Box Mode D'emploi

be shown on the display.
»Use  and  to select the desired track.
»Press the Program button once again to save the track.
»Repeat step 3 and 4 to program up to 20 tracks.
»Press the Play button  to start the playback of the pro-
grammed list.
»To repeat the programmed tracks, press the Program
button during playback and choose "REP ONE" or "REP
ALL" as described in chapter "Repeat mode".
»To delete a programmed list, press the Bluetooth pairing
button twice. The word "PROG" will disappear from the
display.

Karaoke function

The device is equipped with two coequal, detachable
microphones.
» Turn the device on.
»Choose the desired audio source and switch it on according
to the previous chapters. The microphones can also be
used without any music. For that, choose a mode that has
no external audio source connected at the moment or turn
the volume control to the minimum.
» Move the ON/OFF slide control at the microphones to the
upper position to switch them on.
» Adjust the microphone volume by rotating the microphone
volume control to a suitable level.
» Now you can start singing or speaking into the
microphones.
»The microphone holders are immersible into the housing. It
is recommended to push them in while playing.
Take care that you don't place the microphone too close
42
to the speaker – otherwise an acoustic feedback (squealing
from the speakers) can happen. Higher settings of the
microphone volume will result in greater sensitivity for
acoustic feedbacks.

LED light circle

» The product has an integrated LED light circle, that is
controlled via the light button
»Switch on the device.
»By pressing the light button the LED circle is activated:
»Press 1x: LED circle shines blue
»Press 2x: LED circle shines green
»Press 3x: LED circle shines red
»Press 4x: LED circle is off

Cleaning and maintenance

DANGER! Always use a soft, dry and lint-free cloth to
clean the units exterior. If the device is extremely dirty,
you can use a soft cloth dampened with water, or a mild
cleaning solution to clean.
Never use any abrasive or harsh cleaning agents (e.g. alco-
hol, petrol or thinners) as these could damage the controls,
casing or any markings and labels found on the device.
.
43