HTC 450 Manuel D'utilisation page 12

• Plastic bonded tool attached to resin holder disc.
• Tool plate with full set on the 3 resin holder discs.
To do before you operate the
product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 15 .
3. Make sure that the product is assembled correctly
and is not damaged.
4. Put the product on the work area.
5. Make sure that there are diamond tools on the tool
plate and that they are tightly attached.
6. Connect the dust extractor to the product. Refer to
To connect a dust extractor on page 14
7. Adjust the handlebar to set the necessary work
height.
8. Make sure that the motor cable is connected to the
electrical enclosure before the product is connected
to an electric socket.
9. Connect the power plug of the product into the mains
outlet.
12
Daily maintenance
10. Turn the emergency stop button clockwise to make
sure that the emergency stop is disengaged.
11. Make sure that you know in which direction the
motor rotates.
To change in which direction the motor
rotates
CAUTION: The T-Rex tools are made to
rotate in only one direction.
1. Look at the arrow to see in which direction the motor
rotates.
927 - 001 -