Remote Control; Installing The Batteries - Party Light & Sound PARTY-BOX410 Manuel D'utilisation

EN

Remote Control

1. Standby
2. Mute
3. Repeat key (single repeat, repeat all) in USB/TF mode
4. Mode key (Choose from AUX/USB/TF/BLUETOOTH).
Long press to switch the LEDs on the woofer on or off.
5. 0-9 keys
6. Sound mode key (Choose from rock, pop, jazz and etc.) in USB/TF card mode
7. Play/pause (the sound will be muted when paused): Press to pause and resume play
8. Volume-
9. Volume+
10. Previous track
11. Next track
12. Stop
Use of the Remote Control
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim
the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.

Installing the Batteries

Remove the battery cover from the back of the remote control as shown and
insert 2x AAA size batteries ensuring correct polarity
RECOMMENDATIONS FOR BATTERIES IN THE REMOTE CONTROL
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. When the internal batteries are
not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION
Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING
Do not swallow the battery. Danger of chemical burns.Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact im-
mediately a doctor.
Top Panel Description
1. ECHO
2. TREBLE
3. BASS
4. MIC INPUT 1
5. MIC INPUT 2
6. USB /TF CARD INPUT
7. MIC.VOL: adjusts the level of the connected
microphones
8. REC (RECORD TO USB/TF CARD)
9. REPEAT: Press this button to repeat USB/TF
track
10. MODE (SWITCH TO USB/TF/BLUETOOTH/AUX-
11
1
ECHO -
2
TREBLE-
3
7
BASS-
6
4
8 9 10
LED SW
1
4
MODE
12
9 STOP MUTE
VOL+
10
 
CH+ CH-
3
VOL-
REPE EQ
1 2 3
4 5 6
7 8 9
0
ECHO+
TREBLE+
12
BASS+
5
13 14 15
ON
17
16
OFF
MIC.
AUX IN
PRIORITY
2
11
7
8
6
5
3