Cleaning And Maintenance; Technical Specifications - ECG KT 200 DT Mode D'emploi

Overheating and rollover safety switch
• The device will be switched off by internal thermal fuse in case of overheating.
• Overheating could be caused by covering the ventilation openings on the rear of the appliance or by
covering the grill in front. When that happens, unplug the appliance from the outlet and let it cool for 30
minutes. Remove all obstacles and switch the appliance on again.
• If the device stops working, the likeliest cause is a blown fuse. Please, contact an authorized service center.
• The ceramic heater is equipped with a safety switch that in the event of overturning of the heater switches
it off automatically.

CLEANING AND MAINTENANCE

• There are no parts inside the appliance that require your attention or maintenance. Do not attempt to
open the exterior covers of the appliance. This could damage the motor and the heater and void the
warranty. Have all service operations carried out by a qualified repair shop.
• Before cleaning unplug the appliance from the outlet and let it cool thoroughly.
• NEVER use water for cleaning the device and protect it from contact with water under all circumstances.
• The outer cover can be cleaned using slightly damp cloth (if necessary use weak solution of mild detergent).
GB
• You can use regular vacuum cleaner to remove dust from behind the front grill or from the rear ventilation
openings.
• Always make sure that the device is completely dry before using it.
• If you will not use the device for a longer period of time, it is best to clean it and when completely dry, store
it in a plastic bag in a cool and dry place.

TECHNICAL SPECIFICATIONS

Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 2000 W
Remote control: 1 x 3V batteries CR2032 (included)
Noise level: ≤ 50 dB
2 degrees of power settings: 1300/2000 W
WARRANTY:
The following situations void the warranty: Incorrect or inappropriate handling of the device, failure to
observe safety measures applicable to the device, the use of force, alterations or repairs made by a party other
than an authorized service centre.
Components subject to normal wear and tear are not covered under the warranty.
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into plastic
recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specified location for recycling electric and electronic equipment. Prevent negative
impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg-electro.eu.
Changes in text and technical parameters reserved.
36
36 36
08/05