Cleaning And Maintenance; Technical Specifications - ECG ED 80 HN Mode D'emploi

warmth when falling asleep or in the position [0] for complete shutoff of the heating (the control light goes
off ). If you want to use the blanket continually the whole night, move the controller in the position [1].
Dual control: In the double version two people can operate the blanket independently according to their
2.
needs, without its setting influencing each other.

CLEANING AND MAINTENANCE

So that you use the heating blanket always safely, pay attention to the following instructions:
• Check regularly that the blanket was not crumpled or wrinkled.
• Prior to each use check the blanket for signs of wear or damage. Check the state of the power cord and the
plug, and the state of the controller and of the blanket itself. If you are unsure whether the condition of the
appliance allows its safe use, contact an authorized service center.
• The heating conductor in the heating blanket should be evenly spread, without crossing or layering. Check
by passing a hand over the blanket.
• Do not allow the children to jump on the bed with spread heating blanket. If that already happened,
check, if the blanket is not damaged.
• In case of accident or damage (fire, burning by a cigarette, unusual sounds or smells) disconnect the
GB
blanket from the power supply immediately.
Cleaning
The blanket can be cleaned only manually. You cannot wash it in a washing machine and it cannot be cleaned
chemically.
If you want to clean the blanket, disconnect it from power and let it cool down completely. Lay it on an even
surface and clean it using a wet cloth. Make sure that the controller and the power cable do not get wet during
cleaning. Then let it dry thoroughly. Do not use a dryer or a hair dryer. Do not try to speed up the drying by
switching the blanket on!
Storing
Store the unused heating blanket in a dry place. Let the blanket cool down thoroughly before storing it. Do not
place heavy objects on a folded heating blanket to prevent damaging it.

TECHNICAL SPECIFICATIONS

ED 140 HN, ED 140 BE:
Number of controllers: 2 (mutually independent)
Size (length × width): 160 × 140 cm
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 2× 60 W
ED 80 HN:, ED 80 BE:
Number of controllers: 1
Size (length × width): 150 × 80 cm
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 60 W
WARRANTY:
The following situations void the warranty: Incorrect or inappropriate handling, failure to observe safety
measures concerning the product, the use of force, modification or repair by any party other than authorized
service center.
Components subject to normal wear and tear are not covered under the warranty.
32