Installing The Device; Selecting The Installation Location - Dometic StarLight Série Instructions De Montage Et De Service

Installing the device

7 Installing the device
You can fit the device into an existing kitchen installation.
7.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
 Select a well-ventilated location for the device.
 Check the dimensions of the device (fig. 4, page 3 and fig. 5, page 4).
 Ensure the following minimum clearances
– 200°mm to the side walls
– 170°mm to the back wall
– 500°mm between the burner and horizontal surface above the hob
 Ensure that there are no draughts in the installation location.
 Do not operate the device in rooms that are potentially explosive.
 If gimbals are being used, make sure that the cooker is able to vibrate.
 Leave sufficient space for the vibration of the gimbal.
7.2 Installing the device
NOTICE! Beware of damage
A
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
This is how to install the device (fig. 6, page 4 and fig. 7, page 5):
➤ Fasten the side plates using the screws provided leaving a space of
134 mm around the kitchen unit.
➤ Mount the device so that the bolts of the mounting plate hook into the side
plates (fig. 7 , page 5).
14
Dometic StarLight
EN