9/ Safety Steps; 10/ Spare Parts - TecSup BABY Manuel D'utilisation

• The 110/230 VAC mains grid (or generator) being used as a
power source for BABY must be protected by a properly calibrated
differential trip switch.
• Access to the electronics and battery pack is protected
by a non standard screw.
• Do not use the lamp in environments where a risk
of explosion mayoccur or near solvents, gases or
infl ammable dusts.
• Never shine a LED light into the eyes ; the power
given off could cause temporary or permanent damage.
• In extreme
temperature of the dissipater can reach 65°C approximately;
without being dangerous, nevertheless, making children aware
would be wise.
• It is advised to keep the protective caps on the connector points
when they are not being used; the life of the electric points will be
prolonged further.
The following list of spare parts is neither exhaustive nor contractual.
• External glass screen (see #7)
• Mains power cables with standards such as UK, Europe, CH, Italy,
etc.
• Cigarette lighter cable
Cord change requires no action on the BABY product: independent
product.
If the external fl exible cable or cord of this luminaire is damaged, it
must be replaced by a cable or a special cord from the manufacturer
or its maintenance service.
TECSUP - BABY - Manuel utilisateur - 80300106 L - P 30 / 50
BABY

9/ SAFETY STEPS

conditions of

10/ SPARE PARTS

use, the maximum