Trademark Information; Supplied Accessories; Attaching The Stand; Symbols Used In This Manual - Magnavox 32MF339B Manuel De L'utilisateur

Masquer les pouces Voir aussi pour 32MF339B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Trademark Information

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI
Licensing LLC.
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby
Laboratories.
Products that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency.

Supplied Accessories

user manual
(1EMN24339)
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.

Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down
onto it. Make sure not to damage
the screen. At least two people are
required at this step.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by "
when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:
TV
: Analog TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
quick start guide
remote control
(1EMN24479)
(NF802UD)
2
Hang the hook under the bottom
of the main unit to the stand's hole
(shown arrow
the stand in the direction of the
screen (shown arrow
Make sure not to put the AC power
cord between the stand and the
unit.
". Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand
registration card
(1EMN24699)
batteries
(AAA x 2)
3
), then slide down
).
: Digital TV operation
DTV
Phillips pan screw for
attaching the stand x 4
(FPH34200)
Drive Phillips pan screws in the 4
threaded holes at the bottom of the
stand with a screwdriver tightly.
screw holes
screw holes
5
EN

Publicité

Table des Matières
loading

Table des Matières