Improper Use; Installation And Application; Removal Of The Bracket - Adam Hall STCLMP B Manuel D'utilisation

2.2. IMPROPER USE

The following prohibitions on usage and operation apply:
• The product must not be used without additional protection (e.g. safety rope) in
accordance with the German Occupational Health & Safety Regulations (BGV C1 - § 7
Protection against falling objects)
• Exceeding the permitted load capacities according to specifications
• Carrying out of repairs without specialist knowledge
• Operation by inappropriate or unauthorised persons
• Usage when defective or with unsuitable equipment.

3. INSTALLATION AND APPLICATION

3.1. APPLICATION AND SETUP
• Prior to installation, the place of installation is to be inspected for suitability according to
the specifications. Installation is permitted only on a load-bearing beam and in a horizontal
position. If necessary, the load capacity of the beam is to be acquired from the
manufacturer and/or operator.
• Open the clamping jaws by turning the tommy screw until the required span is reached.
• Position both of the bracket's clamping jaws in the profile's groove or on the beam's
supporting surface.
• Now manually turn the tommy screw until the best possible stability is achieved. Tools
should not be used here because excessive force can damage the threads and housing.
Ensure the bracket fits tightly and securely.
• The bracket then requires securing against unintentional falling. Do this by threading
ropes or chains through the specially provided drill hole.
• The bracket (mounting plate) is now ready for mounting your lights, signs, decoration, etc.
• When mounting the object, select a mounting hole appropriate to the maximum load
limit. Five threaded holes are available with maximum loads from 30 – 150 kg. The load
capacity of the profile or beam must also be considered!

4. REMOVAL OF THE BRACKET

• Remove the safety rope/chain.
• Loosen the screw on the bracket until the clamp opens.
• Now remove the bracket and place it in secure storage.
4