Texas Equipment ZMLB5120 Manuel Utilisateur page 7

appliance or the battery pack (as applicable)
except as indicated in the instructions for use
and care.
Do not remove a battery pack from its original
⚫
packaging until required for use.
Do not subject batteries to mechanical shock.
⚫
Observe the plus (+) and minus (-) marks
⚫
battery pack and equipment and ensure
correct use.
Do not use any battery pack which is not
⚫
designed for use with the equipment.
Do not mix battery pack of different
⚫
manufacture, capacity, size or type within a
device.
Keep batteries out of the reach of children.
⚫
Always purchase the correct battery pack for
⚫
the equipment.
Keep battery pack clean and dry.
⚫
Wipe the battery terminals with a clean dry
⚫
cloth if they become dirty.
Batteries need to be charged before use.
⚫
Always use the correct charger and refer to
manufacturer's instruction or equipment
manual for proper charging instructions.
Do not leave a battery pack on prolonged
⚫
charge when noting use.
After extended periods of storage, it may be
⚫
necessary to charge and discharge the battery
pack several times to obtain maximum
performance.
Retain the original product literature for future
⚫
reference.
Use only battery pack in the application for
⚫
which it was intended.
When possible, remove the battery pack from
⚫
the equipment when not in use.
Operation
The battery pack LED light shows the battery pack
capacity and if there are any problems with the
battery pack. The battery pack capacity is
displayed for 5 seconds after the machine is
switched off or the battery pack indicator button is
pressed. The warning symbol on the battery pack is
lit when an error has occurred. See fault codes (6).
When all the LEDs are lit on the battery pack, it is
fully charged (7).
Regularly check that the battery charger and the
battery pack are intact.
The battery pack must be charged before using it
the first time.
BATTERY HANDING
NOTE！
The battery pack is only 30% SOC charged when
delivered.
⚫
⚫
⚫
⚫
⚫
⚫
⚫
⚫
LED 1, LED 2, LED 3
LED 1, LED 2, are lit.
TEXAS battery pack is only allowed to be
charged by appropriate TEXAS Charger (for
voltage of 220-240V, 50HZ, please charge it by
). Working temperature for
ZMLC5120E
charging will be 5~25℃, while the ideal
temperature is 20~25℃.
Put the battery pack in the battery charger.
Make sure that the battery is connected to the
battery charger (1), (2).
The green charging light is lit when the battery
pack is connected to the battery charger (4).
When all LEDs are lit the battery is fully
charged (7).
Remove the battery pack from the battery
charger.
TEXAS battery pack is only allowed to be
charged by appropriate TEXAS appliance such
as TEXAS Li-Ion Chainsaw, TEXAS Li-Ion
Blower, TEXAS Li-Ion Trimmer, TEXAS Li-Ion
Lawn Mower, TEXAS Li-Ion Pole Trimmer,
TEXAS Li-Ion Pole Saw, TEXAS Li-Ion Hedge
Trimmer.
When battery pack is connected with the
appliance, the battery pack will be locked up by
pack release buttons and machine enclosure.
Press on the both release button at the same
time, the battery pack will be unlocked and
disconnected (3).
Low voltage charging: If the battery pack has
been stored with little to no charge for a long
period of time, the battery will go into recovery
mode, which will take 20 hours to fully charge
the battery. This will enhance the life of the
battery. Once it is fully charged, the next
charge will return to standard charging.
LED lights
All LEDs are lit
are lit.
LED 1 are lit.
LED 1 flashes
Battery Pack
Fully charged
(75-100%).
The battery pack is
50%-75% charged
The battery pack is
25%-50% charged.
The battery pack is
0%-25% charged
The battery pack is
empty. Charge the
battery.