Set Console Devices - DeWalt DS100 Guide D'utilisation

To Add a User
NOTE: Up to 6 users including the master user can be programmed.
1. Use the up and down arrows to scroll through the menu until the Add User screen is
displayed. Select OK.
2. Starting with the next available user, enter a four digit access code. To move back a
character, use the down arrow. To move forward a character, use the up arrow.
3. After entering the user code, select SAVE.
4. Next, add the name for the user. Use the keypad to type a name (up to 8 characters).
The character that is being changed will be underlined. To move back a character, use
the down arrow. To move forward a character, use the up arrow. To select letters,
reference the Alpha/Numeric Chart in the Appendix.
IMPORTANT: Write the name and corresponding user number on the Sensor
Location List. Keep this sheet for reference.
5. Select SAVE.
6. Continue to add users or choose EXIT.
To Edit a User
1. Use the up and down arrows to scroll through the menu until the Edit User screen is
displayed. Select OK.
2. Use the up and down arrows to scroll through the users to select the user to be edited.
Select EDIT.
3. To change the user code, enter a new four digit access code. To move back a
character, use the down arrow. To move forward a character, use the up arrow.
Select SAVE.
4. Next, edit the name for the user. Use the keypad to type a name (up to 8 characters).
The character that is being changed will be underlined. To move back a character, use
the down arrow. To move forward a character, use the up arrow. To select letters,
reference the Alpha/Numeric Chart in the Appendix.
NOTE: Write the name and corresponding user number on the Sensor Location List.
Keep this sheet for reference.
5. Select SAVE.
6. Continue to edit users or choose EXIT.
To Remove a User
1. Use the up and down arrows to scroll through the menu until the Remove User screen
is displayed. Select OK.
2. Use the up and down arrows to scroll through the users to select the user to be
removed. Select REMOVE.
3. The system will confirm that the user has been removed. Select OK.
4. Continue to delete users or choose EXIT.

SET CONSOLE DEVICES

The Base Unit contains a siren and a strobe light. They provide notification of an alarm
occurrence. Although it is not recommended, the siren and strobe can be turned off and
will not operate if an alarm occurs.
1. Start at the main screen.
2. Select MENU or press MAIN MENU on the keypad.
3. Using the keypad, enter the master code.
13