Maico TRE 0,4-2 Instructions De Montage page 13

Mounting the enclosure cover

Enclosure type
DANGER:
 Insert the plug of the two connecting
cables, see arrow.
 Short circuit if housing is not tight.
 Ensure correct seat of the circumferential
enclosure seal.
 Place the enclosure cover on the enclosure
bottom and screw together with the 4
mounting screws.
(Tightening torque 1.2 Nm).

Enclosure type
 Close switching cabinet door and lock with
cabinet key.
Startup
Before startup, install all system components
according to their operating instructions.
 Verify agreement with the technical data,
see type plate.
 Switch on the mains fuse.
 Perform a function test in all 5 speed
levels.
7. Maintenance
Maintenance and care activities may be
performed only by qualified electricians.
Terminals and connections must be regularly
checked for secure contacts and cleaned
from soiling if necessary. The device does not
require any maintenance of properly used.
13