Publicité
Les langues disponibles
Les langues disponibles
Disconnect the dryer when not in use or during cleaning
and maintenance operations.
The filter is a fundamental component of the dryer: its
function is to collect lint and fluff that form during drying.
Clean the filter once drying is completed, by rinsing it under
running water or cleaning it with a vacuum cleaner. Should the
filter become clogged, the flow of air inside the dryer will be
seriously hampered: drying times becomes longer and more
energy is consumed. Moreover, the dryer may become
damaged.
The filter is located in front of the dryer seal (see Picture).
Removing the filter:
Rotate the drum manually to remove smaller items
(handkerchiefs) that could have been left inside the dryer.
Avoid using abrasives, steel wool or stainless steel
cleaning agents to clean the drum.
A coloured film may appear on the stainless steel drum
surface: it may be caused by a combination of water and/or
cleaning agents such as wash-softeners. This coloured film
does not affect the dryer's performance.
Water
container
Condenser unit
1. Pull the filter's plastic
handle upwards (see
Picture).
2. Clean the fluff off the filter
and replace it correctly.
Ensure that the filter is
placed flush with the dryer
seal.
Do not use the dryer
unless the filter has been
replaced in its holder.
Catches
Handle
Remove the water container and empty it into a sink or
other suitable drain outlet, then replace it correctly.
Always check the water container and empty it before
starting a new drying cycle.
• Remove the condenser unit regularly (monthly) and clean
off any fluff deposits from the plates by rinsing it with cold
water running on the rear end of the condenser.
Removing the condenser:
1. Disconnect the dryer from the power supply and open the
door.
2. Open the condenser cover (see Picture), unlock the three
catches by turning them 90° anti-clockwise, then pull on
the grip to remove the condenser.
3. Clean the surface of the seals and replace the unit with the
arrows pointing upwards, while making sure that the
catches are securely fixed.
• The external metal and plastic parts and the rubber parts
can be cleaned with the aid of a damp cloth.
• Clean the front air intake grille regularly (every 6 months)
with a vacuum cleaner to remove any lint, fluff or dust
deposits. Furthermore, remove any lint deposits from the
front part of the condenser and from the filter area, using a
vacuum cleaner every so often.
Do not use solvents or abrasives.
The dryer uses ball bearing components that do not
require lubrication.
Have the dryer checked regularly by authorised technical
personnel in order to ensure that the electrical and
mechanical parts work safely (see Assistance).
.ilter
Condenser unit
Air intake
Condenser cover
Tap
Rear
.ront
Publicité
