Filling The Water Tank - Toolland TM76073 Mode D'emploi

• Maintain tools with care. Keep tools clean for better and safer performance.
• Consider work area environment. Do not use electric tools in damp or wet locations. Keep work area well lit.
Do not use electric tools near flammable liquids or gases.
Additional safety instructions for wall paper steamers
• Do not use the appliance near children of animals.
• Do not point the appliance on people, animals or electric appliances.
• Always check if the appliance has been designed for the work surface.
• Always unplug the appliance when it needs to be refilled.
• Only use clean water.
• Do not use cleaning products, chemicals or inflammable liquids. It will damage the appliance.
• Do not submerse the appliance in water or other liquids.
• Do not use the appliance without the water tank cap.
• Avoid contact with the hot parts of the appliance.
• Let the appliance cool down after use.
Assembly
3.
Hose
• Connect the hose to the machine
• Attach it very firmly.
Steamplate
• Connect the steam plate with the hose.
• Attach it very firmly.
4.

Filling the water tank

• Switch off and unplug the appliance before starting to refill the water tank.
• Remove the water tank knob.
• Fill the water tank with a maximum of 4,5L water. Use warm water if you want to shorten the starting time.
• Replace the water tank knob.
• Connect the power supply cord with the appliance.
• Plug in the appliance and switch it on.
• It will take around 10 minutes to warm the water.
• You can start working when steam (without pressure) comes out the steam plate.
• Always wait 2 minutes before unplugging the appliance after use or when you would like to refill the water
tank.
• A safety valve allows steam to escape when the hose is blocked.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 water tank
2 handle
3 hose (3 m)
4 steam plate
6. Operation
Switch off and unplug the appliance before starting to refill the appliance. Always wait 2 minutes before
unplugging the appliance after use or when you would like to refill the water tank.
1. Place the steam plate directly onto the wallpaper for at least 10-20 seconds.
2. Move the steam plate to another section and remove the wall paper.
3. If it is difficult to remove the wallpaper you can repeat it. For some types of wallpaper you can cut in
slightly the paper. This will allow the steam to get better underneath the top layer of the paper.
4. Do not keep the steam plate on the same position for a longer period.
V. 05 – 19/07/2018
TM76073
5 power supply cord
6 automatic mechanism that interrupts the power
supply when water tank is empty
7 water tank knob
4 ©Velleman nv