MediaShop Electric Fireplace Mode D'emploi page 13

BUTTONS AND FUNCTION OF THE CONTROL PANEL & REMOTE CONTROL (Illustration 8+9)
BUTTON
ON
OFF
POWER
TIMER
FLAME -
FLAME +
HEATER
TROUBLESHOOTING
Problem
Unit does not work / does not heat
No flame effect
CLEANING & MAINTENANCE
• Disconnect from the power supply before attempting any maintenance
or cleaning in order to reduce the risk of fire, electric shock to persons
or damage to property.
• Warning - Always disconnect from the power supply before cleaning
fireplace.
• For general cleaning, use a soft, clean duster. Never use abrasive
cleaners. The glass viewing screen should be cleaned thoroughly with
a soft cloth. Do NOT use glass cleaners.
• Periodically check all fixings and tighten if necessary.
FUNCTION
Control panel only:
ON: Enables all functions.
OFF: Turns off all functions on control panel and
remote control.
ON: Enables touch panel functions and remote
control. Turns on flame effect.
OFF: Disables touch panel functions and remote
control. Turns off flame effect.
TIMER button: Controls timer settings to turn off
fireplace at selected time.
Timer settings range from 0,5 hours up to 4 hours
FLAME "-": Makes flame effect dimmer.
NOTE: Flame effect stays on until power button
is turned off. Flame effect must be on for heater
to turn on.
FLAME "+": Makes flame effect brighter.
NOTE: Flame effect stays on until power button
is turned off. Flame effect must be on for heater
to turn on.
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater blows
cool air for 10 seconds before the heater turns
on, and after it turns off.
Possible Solution
• Check if the unit is plugged in the power outlet.
• Check if the unit is in Standby mode. If so, turn the unit ON.
• Check if the heat is turned OFF.
• Check for safety cut-off operation.
• Check if the unit is plugged in the power outlet.
• Check if the unit is in Standby mode. Turn the unit ON.
TECHNICAL SPECIFICATION
Electric Fireplace
• Supply: 220-240V, 50-60Hz
• Rated Power: 1500W
• Bulb: LED light
Remote control:
Battery-driven, 2 x 1,5 V AAA batteries (not included in the pack)
13
ACTION & INDICATION
1. Press ON: Power turns on. All functions
are enabled.
2. Press OFF: Power, flame effect, and all
functions turn off
1. Press once. Indicator light turns on.
Power turns on. All functions enabled.
2. Press again. Flame effect turns off.
Power and all functions turn off.
1. Press once. Indicator light turns on.
Timer is set to 0,5 hours.
2. Press again until desired setting
is reached. Indicator lights show setting.
1. Press once. Flame effect gets dimmer.
2. Press again until desired setting
is reached. Flame effect continues to get
dimmer each time button is pressed.
1. Press once. Flame effect gets brighter.
2. Press again until desired setting
is reached. Flame effect continues to get
brighter each time button is pressed.
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds.
Low heater turns on and blows warm air.
2. Press again. Indicator lights up.
High heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air, then turns off.