Safety Precautions - Sun Fire Link Manuel D'installation Et De Maintenance

Table des Matières

Publicité

Safety Agency Compliance
Statements
Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Sun Microsystems product.

Safety Precautions

For y our prot ection, obs erve th e following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
I
equipment.
Ensure that the voltage and frequency of your power
I
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
I
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution – There is risk of personal injury and
equipment damage. Follow the instructions.
Caution – Hot surface. Avoid contact. Surfaces
are hot and may cause personal injury if
touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
On – Applies AC power to the system.
Depending on the type of power switch your device has,
one of the following symbols may be used:
Off - Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.
Modifications to Equipment
Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.
Placement of a Sun Product
Caution – Do not block or cover the openings
of your Sun product. Never place a Sun
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
Caution – Noise level during normal
operating condition is below 70Db(A). Noise
level during over temperature condition may
be above 70Db(A). Limit exposure during this
temporary condition.
SELV Compliance
Sa fet y sta t us of I/O c on nect ions c omply t o S EL V
requirements.
Annexe B Safety Agency Compliance Statements
B-5

Publicité

Table des Matières
loading

Produits Connexes pour Sun Fire Link

Table des Matières