Safety Instructions; General Guidelines; User Manual - Toolland WEH200 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or to
a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Unplug the mains lead before opening the housing.
Keep this device away from rain and moisture.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the

dealer will not accept responsibility for any ensuing defects or problems.
A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.

It is essential that the device be earthed. Your electric system must be supplied with a magneto cut-out

safety. Have a qualified person carry out the electric connection.
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.

Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if

necessary.
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug

only.
Note that damage caused by user modifications to the device is not covered by the warranty.

Keep the device away from children and unauthorised users.

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
This device should only be used with an alternating current of max. 230 VAC, 50 Hz.

Select a location where the device is protected against frost and low temperatures.

Do not stand under hoisted loads.

Make sure the steel cable is correctly wound around the reel and the pitch is equal the cable diameter.

Observe the maximum load indicated on the hoist, not that on the hook.

Leave at least three turns of cable around the reel so that the cable connection is not under stress.

To avoid danger, do not wind more than 15 m of cable around the reel.

Replace a worn-out cable with a cable with the same specifications.

If the device cannot hoist a load, do not keep pressing the push button. It means the load exceeds the maximum

capacity.
V. 03 – 10/10/2016
WEH200/WEH300

USER MANUAL

3 ©Velleman nv