Technical Data - AEG EZS 5664 Mode D'emploi

English
30
Cleaning
ATTENTION:
Never use harsh or abrasive detergents.
1. Turn the appliance off before cleaning it.
2. The appliance housing can be wiped down with
a slightly damp cloth.
3. Turn the brush attachment to the right and clean it
under running water after every use.
NOTE:
The components cannot be cleaned in the dishwasher.
Charging Station
WARNING:
Pull the plug out of the socket each time before you
clean the device.
NOTE:
The charging station is splash proof.
1. Regularly wipe the brush holder and lid first with a
damp cloth and then with a dry one.
2. Wipe the charging station's exterior first with a damp
cloth and then with a dry one.
3. Allow the brush holder and lid to dry completely
before closing the lid again.
4. Only put the plug back into the power outlet when
the charging station is completely dry.
Removing and replacing the decorative trim for
cleaning
1. Hold the bottom of the charging
station with one hand, with the
other hand push the panel together
as indicated by the arrows and pull
it off the bottom. You can now clean
the decorative trim.
2. To re-assemble the appliance place
the bulge on the underside of the
panel carefully onto the opening in
the charging station as shown. Then
press the panel into place.

Technical data

Model: .................................................................. EZS 5664
Net weight: ...............................................................0.08 kg
Charging Station
Power supply: .................................. 100–240 V~; 50/60 Hz
Power consumption: .................................................. 1.4 W
Protective system: ........................................................ IPX7
Protection class: .................................................................II
Toothbrush
Rechargeable battery: . 260 mA lithium battery, DC 3.7 V
Protective system: ........................................................ IPX7
Protection class: ................................................................III
The right to make technical and design modifications in
the course of continuous product development remains
reserved.
Information on Compliance with
Guidelines
The Elektrotechnische Vertriebsgesellschaft mbH here-
by declares that the appliance EZS 5664 complies with
the essential requirements of the European Directive on
Electromagnetic Compatibility (2004/108/EC) and the
Low Voltage Directive (2006/95/EC).
Disposal
Rechargeable Battery
The toothbrush contains a rechargeable battery.
Remove the rechargeable battery before disposing of
the appliance. If required, please contact our customer
service team.
ATTENTION:
• Rechargeable batteries should not be disposed of
with the normal household waste!
• As a consumer, you are legally obliged to return
used batteries / rechargeable batteries.
Removing the Rechargeable Battery
1. Remove the brush.
2. Rotate the motor part.
3. Remove the silicon located at the centre of the bot-
tom cap.
4. Loosen and remove the screw beneath to remove
the bottom cap.
5. Place the toothbrush on a hard surface and push the
electronics towards the bottom cap to remove it.