Product Care - Wagan Tech Mighty Impact Wrench Guide D'utilisation

4. Attach an appropriately sized socket wrench on the square retainer. The 2
socket wrenches can be flipped to use 4 different diameters.
5. Set the rotation selector to FWD for clockwise or REV for counter-clockwise
rotation.
6. Pull the ON/OFF trigger switch to turn the tool on. Release the trigger switch
to turn the tool off.
7. Do not operate the tool for longer than 10 minutes without interruption.
Afterwards, take 10 minutes to allow the wrench to cool down.
8. After tightening, check the screw connections for visible signs of damage.

Product Care

• Handle the tool and accessories with care and keep them clean to ensure a
long service life.
• Do not make any modifications to the tool. Repairs to the tool or power cord
should be carried out by an authorized service technician.
• Disconnect the plug from the cigarette lighter before cleaning parts of the
tool, or if there is a problem with the tool.
• Do not use caustic, abrasive or solvent-based products for cleaning.
• Use a soft, dry cloth to wipe the tool clean.
• Prevent oil or oil products from entering the plastic casing. The chemicals
they contain could corrode or damage the plastic. Grease and oil-based
grime must be immediately wiped off the tool and accessories with a slightly
damp cloth.
• Store idle power tools out of reach of children and do not allow people
unfamiliar with the power tool or these instructions operate it. Power tools are
dangerous in the hands of untrained users.
• Disposal of this product should only be done in accordance with the current
regulations.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2012 Wagan Corporation. All Rights Reserved.
4