Removable Oven Door; Oven Light Replacement - Danby Designer DER244WC Manuel Du Propriétaire

CARE & MAINTENANCE

Removable oven door

The oven door is removable but it is heavy. It
is recommended that at least two people work
together to remove it.
To remove the door:
1. Open the door to the full open position.
2. Pull the hinge locks up over the hinge hooks on
both sides.
3. Grasp the door fi rmly on both sides, lift slightly
and pull it straight out and away from the oven.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Insert and seat the upper and lower hinge arms
into the oven slots.
3. Push the hinge locks down from the hinge hooks.
4. Close the oven door and make sure it is working
properly. If it seems uneven or does not close
completely, remove it again and repeat the steps
to replace it.
Note: Do not attempt to close the door until it is
properly installed. The hinges could be damaged.
Glass door window
To clean the outside of the glass door window, use a
glass cleaner. Rinse and polish with a dry cloth.
Avoid scratching or impacting the glass window.
Doing so may cause the glass to break.

OVEN LIGHT REPLACEMENT

Important: Before replacing the oven light bulb,
make sure the electrical power is disconnected from
the appliance. Failure to do so may result in electric
shock or burn. Be sure to let the light cover and bulb
cool completely before replacing.
The oven light bulb is covered with a removable
glass cover that is held in place with a bail-shaped
wire. Removing the oven door can make this
process easier.
To remove the light cover:
1. Hold a hand under the light cover so it does not
fall when released.
2. With the fi ngers of the same hand, fi rmly push
back the wire cover holder. Lift off the cover. Do
not remove any screws to remove the cover.
3. Do not touch the light bulb with a wet cloth.
Replace the bulb with a 40 watt appliance light
bulb.
To replace the light cover:
1. Place the light cover into the groove of the light
receptacle.
2. Pull the wire forward to the center of the cover
until it snaps into place. Ensure that the wire is in
the depression in the center of the light cover.
13