Abicor Binzel B 15 Mode D'emploi page 14

4 Putting into operation
4.2 Mounting the wire guide
4.2.1 Liner
4.2.2 PA liner
4.3 Connecting the cable assembly
EN - 6
For using steel wires.
1 Stretch out the cable assembly and remove the gas nozzle and contact tip
from the torch neck.
2 Unscrew the nut from the central connector and slide the liner through the
wire conduit up to the retaining nipple.
3 Tighten the nut again by hand and cut off any excess liner flush with the
torch neck or tip adaptor.
4 Unscrew the nut and pull out the liner.
5 Sharpen the start of the liner to an angle of approx. 40° and deburr the
edge.
6 Slide the sharpened liner through the wire conduit up to the retaining nipple
then screw down the nut and tighten it using a switch key wrench.
7 Screw in the contact tip and attach the gas nozzle.
For using aluminium, copper, nickel and stainless steels.
1 Use the ABICOR BINZEL sharpener to sharpen the start of the PA liner to
an angle of about 40°. Then slide the PA liner through the wire conduit until
you feel it reach the contact tip.
2 Slide the clamp nipple, O-ring and nut onto the PA liner and tighten the nut
under tension.
3 Mark any excess length of PA liner in front of the wire feed rolls and use the
ABICOR BINZEL cutter to cut it off at the mark.
4 Sharpen the cutting point.
NOTICE
• For PA liners with an outer diameter of 4.00 mm, the capillary tube in the
distance adaptor must be replaced with a guide tube.
1 Attach the central connector to the central socket on the wire feed unit and
secure it with the connection nut.
2 Properly mount the connections for coolant supply/return, shielding gas
and the control lead plug.
Welding torch B