Removing The Pressure Reducer - Weinmann OXYWAY Fix I Mode D'emploi

4 Preparation and operation
Result

4.2 Removing the pressure reducer

16 EN OXYWAY
8. Connect the low-pressure hose up to the pressure outlet.
or
If the device has an inhalation outlet: Connect up accessories.
9. Position the contents indicator such that it can be read easily
(Fix and Fast).
10. Perform a function check
check", page 23).
The pressure reducer is installed.
1. Close the oxygen cylinder.
2. Switch the connected device on and off again.
or
Set the inhalation flow until the contents indicator shows
0 bar.
The system is now depressurized.
(see "6.2 Performing a function