Electrical Installation - Honeywell FRIEDLAND FGGA05 Série Manuel D'installation Et D'utilisation

Wall
5.3

Electrical installation

Ceiling
1. Use the camera stand to mark the position of the
mounting holes on the wall or the ceiling.
2. Drill mounting holes (5 mm) into the wall or the ceiling
according to the mounting slots in the camera stand.
3. Insert a supplied wall plug into each mounting hole.
4. Tighten the camera stand to the wall using the supplied
screws.
5. Tighten the camera onto the camera stand. Set the
camera to the correct angle. Tighten the knob.
6. Loosen the thumbscrew.
7. Set the camera to the correct position.
8. Tighten the thumbscrew.
9. Connect the power adaptor to the camera.
10. Switch on the camera.
11. Check the live-view video from the website.
12. If necessary, adjust the camera angle.
1. Connect the camera as shown.
The Internet connection indicator lights continuously to
indicate that the Internet connection is successful.
Note:
The camera must be connected to the same local network as
the IP gateway to ensure recording.
6