Muji CPD-3 Manuel D'utilisation page 4

For U.S.A.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protec tion against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the equipment and/or
the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
CAUTION
Changes or modifications to this equipment
not expressly approved by MUJI LIMITED for
compliance will void the user's warranty.
4
T his p ro du c t has b e en d esign e d an d
manufactured according to FDA regulations
"title 21, CFR, chapter 1, subchapter J, based on
the Radiation Control for Health and Safety Act
of 1968", and is classified as class 1 laser product.
There is not hazardous invisible laser radiation
during operation because invisible laser radiation
emitted inside of this product is completely
confined in the protective housings.
The label required in this regulation is as follows:
For U.S.A.
CERTIFICATION
THIS PRODUCT COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS PURSUANT TO LASER NOTICE NO. 50,
DATED JUNE 24, 2007.
TEAC CORPORATION 1 47 OCHIAI, TAMA SHI, TOKYO, JAPAN
Rear of the unit
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Optical pickup
Type
Manufacturer
Laser output
Wavelength
DTA
: DL-3150-127B
: Sanyo Electronics Inc.
: 7 mW
: 790+10, -15 nm