Listening To The Radio - Muji CPD-3 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24

Listening to the Radio

1
Press the Mode button (MODE).
The source changes to FM.
FM 87.5
The frequenc y
is shown af ter
"FM" is shown.
< The FM button (FM) on the remote control unit
can also be used.
< When a CD is not inserted into the unit, pulling
the DC power cable will also perform the same
operation.
2
Selec t the station you want to
listen to.
Automatic selection
FM 87.5
Hold the skip button (
2 seconds and release it when the frequency
display starts changing continuously.
A station is tuned in automatically, and the
frequency display will stop. Repeat this step until
the station you want to listen to is found.
< To stop the automatic tuning process, press the
skip button (
/
.
/
20
Hold down
/
) for more than
.
/
) briefly.
Manual selection
To tune in to a station the unit cannot tune in to
automatically, press the skip button (
repeatedly to select the station you want to
listen to.
FM 87.5
< Press the skip button (
frequency changes by a fixed step (0.1MHz). Press
repeatedly until the station you want to listen to
is tuned in.
3
Press the volume buttons (−,+) to
adjust the volume.
VOL 05
The volume level
is
shown.
< The volume can be adjusted from the minimum
(00) to the maximum (32).
/
)
.
/
.
/
/
) briefly. The

Publicité

Table des Matières
loading

Table des Matières