Troubleshooting - Kenwood KMM-BT506DAB Mode D'emploi

Troubleshooting

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
Correct characters are not • This unit can only display uppercase letters, numbers,
displayed.
• Depending on the display language you have selected
DAB reception is poor.
"DAB ANT ERR"
"RELATED SERV FOUND" • Press the volume knob to activate Soft-Link. (Page 9)
• Press
Remedy
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 6)
Clean the connectors. (Page 37)
Reset the unit. (Page 4)
and a limited number of symbols.
(page 6), some characters may not be displayed
correctly.
Make sure [ON] is selected for [DAB ANT POWER].
(Page 6)
Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF].
(Page 6)
to cancel.
Symptom
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the device (USB/iPod/iPhone).
"UNSUPPORTED DEVICE" • Check whether the connected USB device is compatible
appears.
• Reattach the USB device.
"UNRESPONSIVE DEVICE"
appears.
"USB HUB IS NOT
SUPPORTED" appears.
• The source does not
change to "USB" when
you connect a USB device
while listening to another
source.
• "USB ERROR" appears.
The iPod/iPhone does not • Check the connection between this unit and iPod/
turn on or does not work.
• Disconnect and reset the iPod/iPhone using hard reset.
Remedy
Connect the antenna firmly.
The playback order is determined by the order in which
file name were recorded (USB).
This depends on the recording process earlier (USB).
with this unit and ensure the file systems are in
supported formats. (Page 38)
Make sure the USB device is not malfunction and
reattach the USB device.
This unit cannot support a USB device connected via a
USB hub.
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off
and on (or reset the unit) before replacing with another
USB device.
iPhone.
ENGLISH
39