Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. It is recommended that if a wood or porous custom drawer
front is installed, a high-quality spray polyurethane finish be
applied to the inner wood surface.
4. For the lens, drill a 5/16" (7.9 mm) diameter hole through
the appearance side of the custom drawer front. This hole
will allow the "ON" Indicator Light to be visible through the
custom drawer front. To secure the lens, use an adhesive
specified for plastic-to-wood application.
5. Install custom handle (not supplied) through custom drawer
front.
6. The custom drawer front is fastened to the stainless steel
drawer by driving 6 screws through clearance holes in the
drawer front into the wooden or other custom made panel.
A
B
E
A. Optional handle
B. Custom door panel
C. Warming drawer front
D. #8-18 x 3/4" (1.9 cm) screws (6)
E. Lens
D
C
D
Publicité
Table des Matières
