Operating; Technical Specifi Cation - DNT Findoo Fix Mode D'emploi

Operating

Slide the power On-Off switch on the right side of the monitor on position. Now turn the monitor on with the
Standby button.The Power LED indicates green. Setup a suitable lighting with the hand grip. At the monitor
you can adjust the brightness and the contrast, which also depends on the pre-setting of the Twin LEDs
If the Image Orientation button is pressed, the picture orientation turns 180 ° or is mirrored.
The signal transmission from hand grip to monitor uses the connector if the monitor is mounted on the hand
grip.
The monitor works, if it is mounted on the handgrip. The power supply as well as the video
transmission uses the connector on the rear side of the monitors cabinet.
Technical specifi cations
Hand grip
Image sensor
Total pixel
View angle
min. illumination
Power Supply
Dimensions
Weight
Camera diameter
Monitor
Display
Pixel
Videosystem
Video output level
Dimensions
Weight
Operating temperature
Operation humidity
CMOS
704 x 576 (PAL)
50°
0 Lux
4xAA batteries
186 x 145 x 41(mm) (without fl exible tube)
530g
16mm
2.4" TFT-LCD
480 x 240
PAL
0,9-1,3Vpp an 75Ohm
100x70x30mm
140g
-10°C~+50°C/+14°C~+122°C
15~85%RH
- 16 -