Safety Instructions; User Manual - Toolland FT101 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or to
a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions

This device is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the device by a person responsible
for their safety.
Children shall be supervised to ensure that they do not play with the device.
Indoor use only. Keep this device away from rain, moisture, splashing and dripping
liquids. Never put objects filled with liquids on top of or close to the device.
Do not use near inflammable products or in explosive atmospheres. Heat can cause fire to
inflammable products even when they are not in sight. Only use in properly ventilated
rooms.
Incorrect use may cause fire.
Do not touch the shafts, tips, or hot air gun as this can cause serious burns. Keep the tips
and hot air away from the body, clothes, or other flammable material. Do not aim the
device at the eyes. Use gloves and/or heat-resistant tools to pick up the PCB assembly to
prevent burns. Always return the irons and gun to their stands between uses; always let
the device cool down after use and before storage.
Place the device on a level, stable, and fire resistant working surface.
Do not inhale solder fumes. The vapours that are released during soldering are harmful.
Therefore, you shall only use the soldering station in well-ventilated areas or under an
exhaust hood (solder fume extractor). Dispose of fume filters and solder residue in
accordance with local regulations.
Never use the device on live electronic circuits. Make sure power to the work piece is cut
and capacitors are discharged.
Do not block the device nozzle. This may cause heat reflection and may damage the
heating element.
Warning! Do not leave the device unattended when switched on.
 Do not use the device if it is damaged or not working correctly.
 In case of gas delivery problems, check if there is gas in the canister. If so, the problem could be resolved
by cleaning the injector.
 Never put down the tip of the device if the flame is lit (keep the flame 10 cm away from objects).
 Keep the tip of the device turned downwards (max 45°), away from persons and animals.
 Immediately replace the hose if it shows abrasions, deterioration or any imperfection.
 Avoid twisting or overheating the hose.
 Warning! When closing the device, some gas may remain in the extension tube and the flame may keep
burning for a while.
V. 03 – 25/07/2017
FT101

USER MANUAL

3 ©Velleman nv