Hendi 230299 Mode D'emploi page 6

• Remove the protective foil protecting the steel
housing of the dishwasher from scratches. Any
remaining adhesive residue should be careful-
ly removed. Do not use any scouring materials.
Leaving the protective foil can cause difficult to
remove adhesive glue foil to the dishwasher's
steel housing.
Connection to the water supply
• ATTENTION: The connection with the water
supply should be made according to the current
safety standards.
• The dishwasher may be connected only to a cold
water supply.* (In case you want to connect it
to a hot water supply, please contact our com-
pany)
• The water supply hose should have a flap valve
(non-return valve) according to DIN 1988.
• The water supply hose/pipe should be rinsed be-
fore the appliance's connection.
Drainage connection
• The outflow is accomplished through gravity
force (natural flow). The outlet hose should be
EN
connected either directly to the main drainage -
where a pipette for odours is anticipated, or wa-
ter runs directly to a drainage well in the ground,
which has a pipette for odours.
Electrical Network connection
• ATTENTION: All electrical work must be carried
out by a suitably qualified and competent person.
• The dishwasher operates under specific voltage
depending on the type of the dishwasher.
• You should supply the power, depending on the
appliance's power reception (the electrical con-
nection should be made by authorized electri-
cians). Specifications should be met according
Protective duct connection and voltage compensation
• The electrical safety of this appliance is ensured
only if the protective duct has been connected
and checked properly. The corresponding spec-
ifications should be met at this point (see para-
graph 1.5).
• In addition, the appliance should include a volt-
age compensation system.
6
• The appliance should be placed horizontally.
Possible inclinations should be corrected using
a spirit level.
• Following the successful installation, the dish-
washer should be cleaned thoroughly with a con-
ventional detergent before it is put into operation.
• The water supply hose/pipe should have a min-
imum internal diameter of 16 mm and the con-
nection with the hose should be 3/4 inch.
• All hose collars should be adjusted in a fixed po-
sition before the appliance is put into operation.
• The dishwasher can be only connected to a
well-functioning softener.
• ATTENTION: The water pressure must be be-
tween 2 and 5 bar.
• ATTENTION: The outlet hose should not be
placed higher than a level (as given for each ap-
pliance's type) from the lower side of the dish-
washer's dispenser.
to the corresponding parts of DIN, VDE, D100,
the EVU connection terms, the relevant ZH 1/37,
chapter 7.2 - as well as the current specifications
for accident prevention.
• Respectively, the appliance must be connected
to a direct power supply electrical installation
through an HO7 RN-F cable with load relief of the
appliance.
• For this reason, the backside of the appliance has
a screw with the indication "voltage compensa-
tion".
• Following the electrical connection, the action
of the protective duct, the voltage compensation
and the insulation value should be checked ac-
cording to the existing provisions of DIN VDE.