Cleaning The Condenser - Gamko Maxiglass MAXI 300 Mode D'emploi

Installation
The cabinet should not be placed in direct sunlight!
1. The cabinet should be installed on a level surface.
When the cabinet is uneven, the doors will not close properly.
2. After installation, leave the cabinet standing for at least two hours
before switching on to avoid damaging to the compressor.
3. Voltage: for the correct voltage please refer to the indication plate
inside the cabinet.
4. For an optimum temperature, install the cabinet in a position where
adequate air circulation is guaranteed. For lower costs, higher cooling
capacity.
The garantee will be void if the ventilation vents of the product are
partly or wholly obstructed. An unrestricted circulation of air is essen-
tial to ensure optimal cooling performance and a long working life.
5. Do not cover the bottom plate with air flow grills.
6. The temperature in the Maxiglass cabinet can be adjusted by the ther-
mostat. (See thermostat manual included)
7. The cabinet has an independent on/off switch (inside cabinet)
The cabinet is also fitted with an independent switch for the light.
Turn off the light at night.
8. Automatic defrost is standard on all Maxiglass cabinets.
9. The ideal temperature is dependent upon affected by the ambient
temperature.
Cleaning the condenser
Clean the condenser, once a month, by means of a vacuum cleaner or a
brush.
18