Simu T5EHz Notice Originale page 7

3
Compatible transmitters
1 : 1/5 channels Wall Hz transmitter/ Memory Hz
2 : 1/5 channels Mobile Hz transmitter
3 : Color Multi 16 / Timer Easy / Timer Multi transmitters
4 : Hz Sun sensor
Location of the PROG key on Hz transmitters:
Do not position the transmitter near metal in order to avoid
range losses.
4
End limit adjustment
If the installation includes several motors, only one motor is to be powered during this programming
procedure. It will avoid interferences with the other motor during the procedure.
4.1- Learning mode:
- Switch ON the motor.
- Simultaneously press the UP and DOWN keys of a Hz transmitter. The
motor will run for 0,5 second in one direction and then in the other.
The transmitter now controls the EHz motor in unstable mode. Go to
stage 4.2.
4.2- Checking the rotation direction:
Press the UP key of the transmitter:
a
>>
a- If the motorized tube runs in the UP direction , go to next stage (4.3).
b- If the motorized tube runs in the DOWN direction, reverse the rotation direction by pressing the Stop key for at least
3 seconds. The motor will run for 0,5 second in one direction, then in the other direction. Move to the stage 4.3.
4.3- Adjustment of the end-limits - memorizing the end points:
The end limits of the T5EHz are adjusted in 4 different ways depending on the following conditions :
- Bottom slat stop or not, rigid* or flexible link between the rolling shaft and the shutter.
A
*V.A.R
V.A.S
Easylink
OctoEasy
A 1
OK 4.3
>> >>
b
B
*V.A.R
V.A.S
Easylink
OctoEasy
2
1- Simultaneously press the UP and DOWN keys of a Hz transmitter. The
motor will run for 0,5 second in one direction and then in the other.
2s
2- Press the "stop" key for 2 s. The motor will run for 0,5 second in one direc-
tion and then in the other. The operation is completed. Go to stage §5.
1 2
>> >>
C
(12 transmitters max. for one motor)
3
ON
OK
>>
D
4
>>
4.3
>>
EN 2/5