Led Light - Deltaco Gaming GAM-107 Manuel D'utilisation

ENG
1. Left button
2. Right button
3. Wheel button
4. Forward button
5. Backward button
6. DPI button
7. On/off button
8. LED mode button
DPI
Use the DPI button to change the DPI.
The DPI can also be changed via the
software.
USB Polling rate
The default polling rate is set to
1000 Hz.
You can switch polling rate between 125
Hz and 1000 Hz by pressing and holding
the wheel button (3.) and backward but-
ton (5.) for 3 seconds. Red LED = 1000
Hz. Green LED = 125 Hz.
You can adjust the polling rate via the
software to: 125Hz / 250Hz / 500Hz /
1000Hz.

LED light

Press and hold the LED mode button for
3 seconds to turn on or turn off the LED
lights.
Short press changes the LED mode.
Power features
The mouse will enter sleep mode after
10 minutes. Press any key to wake up
the mouse.
When you move the mouse the LED lights
turn off automatically.
Low battery: When battery has less then
30 % left, the LED flashes red rapidly.
When the battery has less then 10%
left, the mouse will automatically
power off.
While charging: When battery is 30-90%
charges, the LED flashes yellow, when
it is 90%-100% charged,
green.
it is static
Pairing
The mouse and receiver have been paired
at factory. Pairing might still be
needed.
To pair: Press and hold left button
+ right button + wheel button for 1
second.
The LED will flash yellow. Insert the
receiver on a PC. The pairing is now
successful.
Software
Download the software at
www.deltacogaming.com
Cleaning
Clean the product by using a dry cloth.
Safety instructions
1. Keep the product dry. Keep it away
from all liquids. This product is not
waterproof.
2. Do not open up or try to repair the
product by yourself.
3. Keep the product and packaging out
of reach of children to prevent acci-
dents and choke hazards.
4. Do not drop or expose to shock
damage.
Warranty
Please, see www.deltaco.eu for warranty
information.
Support
More product information can be found
at www.deltaco.eu.
Contact us by e-mail: help@deltaco.eu.
5