EHEIM LEDcontrol+ Mode D'emploi page 13

•Only carry out the activities that are described in these instructions.
•Never make technical alterations to the device.
•Use only original spare parts and accessories for the device.
•Immediately disconnect all equipment in the aquarium from the mains
supply following a water leak or the tripping of the residual current pro-
tection device.
•Always disconnect all equipment in the aquarium from the mains supply
when it is not in use, before you install and / or remove equipment and
before all cleaning and maintenance work.
•The device must not be placed on or inside the aquarium cover.
•The electrical data of the device must correspond to the data of the
mains supply. This data can be found on the rating plate, on the packa-
ging or in these instructions.
4. Installation
The device is operated in connection with EHEIM powerLED+ lamps. Refer to
the operating manual of the lamp, in particular the chapter about safety, start-
up, service and maintenance!
Danger! Electric Shock!
Do not place the device on or in the aquarium cover!