Menu Settings - OHAUS CKW Série Instructions D'installation Et D'exploitation

EN-6
Reassembly
• Before re-assembly, check that the liquid-tight connector is fully tighted.
• Check that no wires or cabling will be pinched when the two housing
sections are closed.
• Lift the front housing section back into place over the rear housing section.
• Replace the 4 side screws*.
*Note: It may be necessary to apply a moderate clamping pressure to the two
housing halves while replacing the side screws. This pressure compresses a
rubber gasket and insures the proper water tight seal for the housing.
When properly installed, the Relay Option board is automatically detected by the
system's software. Installation is confirmed during the power on display
sequence with the message "
OPERATION

Menu Settings

Figure 5 illustrates the I/O Menu that is used
to configure the optional input and output
device parameters, (Relay Output control
and an External Input signal, such as a foot
switch input). This section is a copy of the
information appearing in the CKW Indicator
Instruction manual.
".
I/O (Section 3.6.6)
Reset:
External Input: Off, Tare, Zero, Print,
Input Beep:
Relay Output:
End
CKW Relay Option Kit
No, Yes
Units, GNT, Accumula-
tion, Start-Stop,Tare-
Start-Stop
Off, On
Type, Sequence, Contact
Figure 5. I/O Menu.