Customer Satisfaction - Homak RD00820310 Manuel Du Propriétaire Et Mode D'emploi

ASSEMBLY
1. During assembly, do not tighten bolts until all components are aligned
properly, and then tighten fully.
2. Turn cabinet on its side.
3. Remove sixteen - M6 x 12 bolts, lock nuts, and washers. Connect four
legs to the cabinet using bolts, lock nuts and washers.
4. While keeping the cabinet upright, remove eight M6 x 12 bolts, lock
nuts, and washers to connect the metal shelf to the legs.
5. After assembly is completed, level cabinet and fully tighten all bolts.
OPERATION:
1. Fill unit with water-based solvent just below the level of the parts shelf
before plugging into the electrical outlet.
2. Open top lid and place parts on removable tray.
3. Position the adjustable nozzle over the parts.
4. Turn the power switch to the ON position.
5. Clean parts as needed.
6. When finished, turn switch to OFF position.
7. Clean up work station.
8. Fusible link must be replaced if triggered.
9. Unplug compressor and drain unit when not in use.
MAINTENANCE:
Powder Coat Finish
For heavy build-up of dirt and grime, our powder coat paint finish can be
cleaned with spray wax. Lightly spray the wax on the surface, and gently
wipe with a soft, dry microfiber cloth.
Window cleaner and a soft cloth dampened with water can be used to
clean the finish on a regular basis.

Customer Satisfaction

All mechanical parts are inspected and adjusted for proper use before
shipment; however, there may be some shifting of parts during transit.
Should any item not operate correctly, please call customer service at
1-800-874-6625.
- 3 -