Runpotec RUNPOMETER RM35 Notice D'emploi page 12

ENGLISH
12
INSTRUCTIONS FOR USE
General information
Switch on by pressing any button. 10 minutes after the last interaction,
the RUNPOMETER switches off again.
(The time can be changed in the menu settings - 5. AutoOFF time)
Standby mode – Activates 1 minute after last interaction - switch back on by
pressing any button or moving the measuring wheel.
(The time can be changed in the menu settings - 4. Standby time)
Display/keys
∑ 1 (Total 1) – ∑ 2 (Total 2) – After pressing the respective button, the current
E
counter reading (positive or negative) is added to TOTAL 1 or TOTAL 2 and
F
the current counter reading is set to 0.
Hold the button in question down for 3 sec. to reset the value to 0.
MEASURED VALUE DISPLAY +/- (positive/negative)
G
RES button
D
ACTUAL – Counts down the set countdown value to 0 in the pull direction
H
and outputs an audible signal. Then restarts.
COUNTDOWN – Preset the desired measuring length.
I
Adjust with the Plus
Fine adjustment - short press – fast adjustment - hold down.
Disables the countdown function - resets the value to 0.
Menu settings
Press and hold the
activity, the settings menu is closed after 30 sec.). Press the
again to browse the settings. To change the current setting, press the Plus
Minus keys. The value is saved.
C
1 Display intensity – backlighting
2 Duration of display backlighting
3 Audible signal volume
4 Standby time – Time until standby mode is activated - the display is
switched off after this. The device can be reactivated by moving the
measuring wheel or pressing any button.
5 AutoOFF – time, time to automatic shutdown
(from the start of standby mode to completely switching off)
6 Meter/Feet – the selected unit of measure flashes
7 Software version – current software version
Absolute measured length in kilometres (CAUTION - guide value only)
All images are representative. Changes and printing errors excepted.
STRONGEST CABLE PULLING
hold down for 3 seconds to reset the value to 0.
/Minus
B C
menu button for 2 sec. to open the settings (if there is no
A
keys.
WWW.RUNPOTEC.COM
menu button
A
/
B